ZowieBox supports HDMI audio output or line-in audio output. If users need to output line-in audio to HDMI, please log in to the ZowieBox web console, and click Setting->Audio to reach the audio configuration interface.
Switch the audio source to line-in and make sure the sampling rate is not 16KHz.
After successfully saving the audio parameters, click Video -> Output, and make sure that the HDMI mute is not turned on and is not switched to loop out.
1) Log in to the ZowieCAM web page
2)Click 'Setting->Camera->Image->Start Calibration ,then manually twist the focus ring until it is completely sharp.
3)Then click 'End Calibration'on the web page.
The specific hardware versions and corresponding functions are as follows:
(1) Please use official NDI software, such as NDI monitor, to check whether the NDI source can be decoded normally.
(2) Please check whether the IP address displayed by the NDI source is in the same network segment as the IP address of ZowieBox.
Learn more
