Method 1. You can use the IR remote to restore the default IP address:
Press [*] + [#] +[MANUAL]
The default IP address: 192.168.100.88
Method 2.
1. Open web browser, type camera’s IP address to go to the camera login page.
2. Log in to the camera’s web interface.
3. Click [System]-[Factory Default]
Then you can see the IP address, username and password have been restored as the picture below.
1) Log in to the ZowieCAM web page
2)Click 'Setting->Camera->Image->Start Calibration ,then manually twist the focus ring until it is completely sharp.
3)Then click 'End Calibration'on the web page.
The specific hardware versions and corresponding functions are as follows:
(1) Please use official NDI software, such as NDI monitor, to check whether the NDI source can be decoded normally.
(2) Please check whether the IP address displayed by the NDI source is in the same network segment as the IP address of ZowieBox.
Learn more
