ZowieBox is set to loop out by default. If you need to switch the output, please log in to the web console first, and click Setting->Video -> Output. Turn the loop put button off and click Save.
In decoder mode, all decoding has to be disabed first in order to switch Video Out to HDMI output.
1) Log in to the ZowieCAM web page
2)Click 'Setting->Camera->Image->Start Calibration ,then manually twist the focus ring until it is completely sharp.
3)Then click 'End Calibration'on the web page.
The specific hardware versions and corresponding functions are as follows:
(1) Please use official NDI software, such as NDI monitor, to check whether the NDI source can be decoded normally.
(2) Please check whether the IP address displayed by the NDI source is in the same network segment as the IP address of ZowieBox.
Learn more
